Remove mildew and mold from your spa cover

By maintaining proper water chemistry you reduce the likelihood of mildew and mold on your vinyl spa cover. However a Spa can be located in a very humid environment and sometimes mildew and mold cannot be avoided. Here are some ideas to remove mildew and keep you vinyl spa cover looking good.

Remove the foam cores from the vinyl spa cover. Use some mild liquid soap and water and use a soft bristle brush to scrub the inside and outside of the vinyl cover. It is important to use a brush with mildew and mold to clean it off. Place the vinyl cover in the sun to allow it to thoroughly and completely dry. Place the foam cores in the shade and allow them to completely dry as well.

Spray both the foam cores and the inside of the vinyl cover outer with a mold and mildew inhibitor. Then allow to completely dry before re-inserting the foam cores back inside the vinyl cover. Now make sure the chemical of the spa is correct and keep it maintained as this will assist with keeping mold and mildew away from the spa cover.

Comments are closed